Vrei sa primesti notificari de la Publi24?

Trimite unui prieten

Trimite

Modul ceas real RTC DS1302 Real Time Clock Module, AVR ARM + baterie

17,99 RON
Valabil din 07.01.2020 16:06:11
Specificatii
Subcategoria diverse
Descriere Electronice

Livrare gratuita in Bucuresti (inclusiv in weekend):
- a treia zi (la adresa)
- a doua zi (la adresa - pt. achizitii peste 89 lei)
- oricand in zona piata unirii
(optional livrarea in Bucuresti la adresa in aceeasi zi e contra cost)

(Accept criptomoneda)

Livrare in tara:
- Posta 12 lei
- Fancourier 25 lei, cu verificare colet
- Cargus 27 lei, cu verificare colet

- Garantie 30 zile
- Cod produs: D439

Bateria CR2032 este inclusa


Description
Real time clock with the year 2100 to calculate the seconds, minutes, hours, days, weeks, months, years, the ability, as well as the ability to leap year adjustment
1.31 8 temporary data storage RAM
2.Serial I / O port pin makes the least number of ways
3.Wide range of operating voltage 2.0 5.5V
4.Current 2.0V, less than 300nA
5.Read / write clock or RAM data transmission when there are two single-byte transmit and multi-byte character sets transfer mode
6.8-pin DIP package or optional 8-pin SOIC package assembly according to the surface
7.simple 3-wire interface
8.Vcc = 5V and TTL-compatible
9.Optional industrial temperature range -40 to +85
10.Dual power tube for the main power and backup power supply

Parameters:
1 PCB a single panel, size: 44mm * 23mm * 1.6mm
2 with 4 holes, about 3.1mm in diameter
3 genuine spare battery for the celestial sphere CR2032, Voltage 3V, current is 260mAh, non-rechargeable batteries.
4 Crystal 32.768KHz, matching capacitance 6pF, size 2 * 6mm
5.DS1302 made large 8-pin DIP chip, chip, IC Block below for easy replacement and plug the chip al3x 5tq
6 module operating voltage compatible 3.3V/5V, 5V and 3.3V microcontrollers can be connected with
7 Operating temperature: 0--- 70

NOTE:
Wiring (to provide the program, for example, can take any IO port, the port defined in the program can be modified):
VCC → +5 V/3.3V
GND → GND
CLK → P02
DAT → P01
RST → P00
1.VCC and GND must not be reversed, or it will burn the chip
2.51 MCU P0 port requires a pull-up, if your single-chip pull-up resistor is not connected, you can port the data cable to the other

Adauga fisier

Fisierele acceptate sunt: jpg, jpeg, png, gif cu o marime maxima de 10Mb.

    Fa oferta
    alex

    Vezi toate anunturile
    Solicita livrare gratuita cu verificare colet. Afla mai multe detalii aici
    Ati atins limita de mesaje trimise pe zi
    Pentru a putea trimite mai multe mesaje accesati abonamentul VIP
    ×
    Anuntul e salvat ca favorit!
    Vrei notificari in timp real pentru anunturile favorite?
    ×
    Anuntul a fost sters de la favorite!