Sim 5320e, umts, hsdpa, 3g, gps, uart arduino gsm shield modul

Specificații

Descriere

Sim 5320e, 3g, gps, umts, hsdpa uart arduino gsm shield modul



Acest modul functioneaza si pe 3G + AUDIO (MIC+ SPEAKER)

"> Am testat personal cu SIM 3G + FULL AUDIO si functioneaza perfect "<

- Dual-Band UMTS/HSDPA 900/2100MHz (3G Network)
- Quad-Band GSM/GPRS/EDGE1900MHz (2G Network)

Produsul vine ca in poza si are cele 2 antene incluse (GSM+GPS si cablul sma adaptor de la antena GPS)



Description

keyestudio SIM5320E 3G module is a mobile phone module, it can be used for GPRS data transmission, supporting both Mobile and Unicom. This module has the function of GPS positioning, with the features of powerful functions and less external circuits,etc. When registering the network and RF multi-slot sending,the current consumption peak may reach 2A, which will inevitably lead to voltage sags, so the power system generally requires more than 2A current supply capability.

Interface Explanation

Power Supply: DC 5V 2A or above.
Communication Interface: a group of TTL-level serial port, compatible with 5V/3.3V microcontroller; with a USB interface, can be directly connected to the computer debugging.
GPS Antenna Interface: a group of IPXmini antenna interface, the default connecting to active GPS antenna.
GMS Antenna Interface: a group of IPXmini antenna interface, the default providing PCB antenna.
SIM Card Interface: drawer type
USB Interface: mini USB interface.
Voice Mike Interface: Lead out, the interface is a 2.54 * 4P single row pin form.
Other Interfaces: a group of IIC interfaces, a group of interface can control the module s opening and closing (the module default self-starting).
Indicator LEDs: one LED is used to indicate the working status of the module; another 0603 LED is used to indicate the network status.

3 Preparation

1 Insert the SIM card
2 J2: power supply DC 5V 2A
3 3G ANT interface: connecting 3G antenna
4 GPS ANT interface: connecting GPS antenna
5 Connecting to MICRO USB interface. (5a5i0) al3x
Done drive installation, it will build communication between USB and system,5 ports
will be mapped on the system as follows:
USB Modem COM port used to dial-up networking.
AT command COM port used to process AT command.
NMEA COM port used for GPS information output. r3d
Diagnostics COM port used for debugging, grab the log information of module.

- - - - - - - - - - - - - - - - - - - - - - - - -

Livrare in Bucuresti si in tara:

www.digitalelectron.wordpress.com/livrare Publi24_1550242080